Any of you guys/gals running with an ARB Awning mounted on your rig I've got a question for you. I want to mount an awning lengthwise inside the rear lip of my Leer 700 fiberglass tonneau cover parallel with the tail gate. The inside dimensions are ~58". The closest sized ARB awnings are the 1250 mm (~49"; too short) or 2000 mm (~78"; too long). My question is this; If I were to get the 2000 mm, can the HW be cut down to a width near ~58" wide and then reassembled. And the awning fabric itself, is it on a roller or does it just get rolled up during tear-down. I would assume that needs to be cut to width also. The poles that extend out, are they fixed length and it appears that they are at a minimum the length of the main channel, will they need to be shortened also. The awning fabric itself could be altered and is possibly the least of my concerns. Anyway, the plan is to be able to mount this under the rear lip of the tonneau and when raised opened, the awning can then be setup out over the rear of the truck. I may just have to live with the 49" being a little short but I'd really like to get a better sized fit... Thanks for any suggestions...
