Welcome Guest!!

Welcome to SCCX, for full access to the forums, please register and join our community, it's free.

Author Topic: Trail welder  (Read 127 times)

Celt

  • Hero Member
  • *****
  • Location: In the basket of Deplorables.
  • Posts: 3455
  • 4wd Pts: -20001
  • 8646
Trail welder
« on: November 26, 2021, 12:48:12 PM »
Any of you guys seen this: https://www.ruffstuffspecialties.com/bunweld.html I think it could solve a lot of issues instead of constantly having to rig something up. At $300 it is really competitively priced and won't take up much room. I like it better than the units that run off your alternator as you don't have to get a high output unit and figure out how and where to mount the welding unit. This with a little bar stock or a few tabs might well be on my to get list.
Isaiah 6:8

JFanaselle

  • BOD
  • Hero Member
  • ******
  • Location: Murrieta, CA
  • Posts: 2349
  • 4wd Pts: 12000
    • 2010 Xterra S 4x4
Re: Trail welder
« Reply #1 on: December 01, 2021, 10:54:13 AM »
Interesting little setup. I searched some YouTube videos, and it looks like it puts off some pretty good heat.



It doesn't require the high output alternator, but it does need two batteries (24 volts). Looks like the kit comes with the cables to wire two 12V batteries in series with one another. This would be a good setup if you run dual batteries or if you're wheeling with other rigs and can pull a couple of batteries out of them. I have to wonder how much use you can get before the batteries need to charge back up, but it does seem like it could get you out of a jam (think: CHUSA in Death Valley).

 


Powered by EzPortal